Diploma in Plastics Mould Technology at Central Institute of Plastics Engineering and Technology, Korba

Central Institute of Plastics Engineering and Technology, Korba offers Diploma in Plastics Mould Technology as a 3-year diploma degree. There are 60 seats in each batch.

Central Institute of Plastics Engineering and Technology, Korba is a public/government institute. This page brings together what is on record for this course at Central Institute of Plastics Engineering and Technology, Korba — fees, seats, eligibility, the admission route and placements — so you can judge it before you apply.

Central Institute of Plastics Engineering and Technology, Korba has not published a fee for Diploma in Plastics Mould Technology on our record yet. When you ask, ask for the total across all 3 years — not just the first-year figure — and whether hostel and exam fees are included.

To get into Diploma in Plastics Mould Technology, you usually need Class 10 (or Class 12, for some diplomas).

Admission to this kind of course is usually through state polytechnic entrance exams. Reserved-category candidates generally get a relaxation in the minimum marks. Check Central Institute of Plastics Engineering and Technology, Korba's prospectus for the exact cut-off this year.

In most years, admission follows these steps:

1. Check that you meet the eligibility above and register for the entrance exam in time.
2. Take state polytechnic entrance exams and keep your scorecard.
3. Apply to Central Institute of Plastics Engineering and Technology, Korba or through the enquiry form on this page, and take part in counselling if a state or central body runs it.
4. Once you are offered a seat, verify your documents (marksheets, ID, category certificate if any) and pay the admission fee to confirm it.

Central Institute of Plastics Engineering and Technology, Korba runs 2 Diploma specialisations in all. If this one is not quite right, compare it with:

• Diploma in Plastics Technology

Ask yourself — and the college — these questions first:

• Do the subjects of Diploma in Plastics Mould Technology genuinely interest you? You will spend 3 years on them.
• What will the full course cost, including hostel and living costs?
• What do recent graduates of this course actually go on to do?
• How does Central Institute of Plastics Engineering and Technology, Korba compare with other colleges offering Diploma?